• Home
  • LOGIN
    • LOGIN
    • Log in with Facebook!
  • CHANGELOG
    • RPI OPI V4
    • RPI OPI V5
    • PC Based V2
    • Newifi V2
    • MXQ RK3229
  • HOW TO
    • Flash Your Pi
    • Reprogram Arduino
    • Use LC Account
    • Reload Direct To Loadcentral
    • Use ngrok
    • Build remote cashbox
    • Use your remote cashbox
    • Build MikroTik based vendo
  • OUR VENDOS

How to reprogram your Arduino board under v3.x.x

Reprogramming is now done from inside the local admin panel

Make sure that you have this wiring in your Arduino board before you proceed.


Step 1

Login to your local admin panel ang go to the vendo settings page. Turn on programming mode as shown below


Step 2

Restart your vendo by going to vendo maintenance page then press the reboot machine button.


Step 3

After the reboot, go back to your vendo settings page. 3 buttons will be visible for the reprogramming of your Arduino board.


Step 4

Select your corresponding board to proceed. It should only take about 2 to 3 seconds to complete the reprogramming.


Step 5

After successfully reprogramming your Arduino board turn off the programming mode as shown below.


Step 6

Reboot again your machine


Step 7

A running status will be shown under your dashboard once the steps above is followed accordingly. You can now test your coinslot for the super fast reading.

Data Policy | Terms of Use

Copyright © 2019 - 2020 iWiFi Portal, All rights reserved | This template is made with by Colorlib